Chapter 2. Installing options
7
Removing the support bracket assembly
When working with some options such as hard disk drives, microprocessors, and
memory modules, you must first remove the support bracket assembly to access the
location of the option.
Complete the following steps to remove the support bracket assembly.
1. Disconnect the support bracket assembly fan cable from the connector (SYSFA3)
on the system board. For the location of the fan cable connector, see “System and
PCI extender board internal cable connectors” on page 4.
2. Pull out, about 152.4 mm (6 in.), on the end of the support bracket assembly
located at the rear of the server.
3. Pull the front end of the support bracket assembly away from the server and place
the assembly aside.
To reinstall the support bracket assembly, reverse the previous steps.
