10
IBM xSeries 200: Installation Guide
7. Touch the static-protective package containing the adapter to any unpainted
metal surface on the server. Then, remove the adapter from the package. Avoid
touching the components and gold-edge connectors on the adapter.
8. Place the adapter, component-side up, on a flat, static-protective surface.
9. Set any jumpers or switches as described by the adapter manufacturer.
10. To install the adapter, carefully grasp the adapter by its top edge or upper corners,
and align it with the PCI slot guides; then, press the adapter firmly into the PCI
expansion slot.
Attention:
When you install an adapter in the server, be sure that it is completely
and correctly seated in the PCI expansion slot before you turn on the server.
Incomplete insertion might cause damage to the system board or the adapter.
11. Connect required cables to the adapter.
Attention:
Route cables so that they do not block the flow of air from the fans.
12. If you have another adapter to install, do so now.
13. If you have installed a full-length adapter, rotate the front adapter support bracket
to the closed (locked) position.
14. Reinstall the rear adapter retaining bracket; then, rotate the bracket to the closed
(locked) position.
15. If you have other options to install, do so now.
16. Reinstall the side cover, see “Installing the cover” on page 23 for details.
17. Reconnect the external cables and power cords; then, turn on the peripheral
devices and the server.
