14
IBM xSeries 232: Installation Guide
Note:
The illustrations in this document might differ slightly from your hardware.
To install an additional microprocessor:
1.
Review the safety precautions in “Safety” on page v and review the “Handling
static-sensitive devices” on page 3.
2.
Turn off the server and peripheral devices and disconnect all external cables and
power cords.
3.
Remove the cover.
4.
Remove the terminator card from the microprocessor connector.
Note:
After you install the microprocessor, store the terminator card in the static-
protective package for future use.
5.
Install the microprocessor.
6.
Install the voltage regulator module (VRM) included in the microprocessor kit.
Attention:
When installing or replacing a VRM, use only a VRM specified for use
with the xSeries 232 server. Use of other VRMs might cause your server to
overheat.
7.
Remove the clear plastic liner from the thermal material on the underside of the
fan sink and discard.
8.
Set the fan sink into place.
Microprocessor 2
Fan sink
(Remove thermal tape
liner on installation)
Microprocessor 1 location
VRM 1
VRM 2
Terminator
card
