Three-pin jumper blocks
With the three-pin jumper blocks, each jumper covers two of the three pins on a pin
block. You can position the jumper to fit over the center pin and either of the other
two pins.
The following illustration identifies pins 1, 2, and 3 on a three-pin jumper block.
2
1
3
To change a jumper position for a three-pin jumper block:
1. Turn off the server; then, disconnect the server power cords.
2. Remove the server cover (see “Preparing to install options” on page 46).
3. Lift the jumper straight off the pin block.
4. Align the holes in the bottom of the jumper with the center pin and the pin that
was not covered previously.
5. Slide the jumper fully onto these pins.
6. Reinstall the server cover and connect the cables (see “Completing the
installation” on page 85).
Chapter 5. System board and processor board
105
Summary of Contents for eServer 240 xSeries
