POST message
Description
1600
The Advanced System Management Processor is not functioning.
Action:
1. If a jumper is installed on pins 7 and 8 of jumper block J20 of the system board,
remove it or move it to pins 8 and 9.
2. Disconnect the server from all electrical sources, wait for 30 seconds, reconnect
the server to the electrical sources, and restart the server.
If the problem persists, have the system serviced.
1601
The Advanced System Management Processor BIOS needs to be updated.
Action:
1. Disconnect the server from all electrical sources, wait for 30 seconds, reconnect
the server to the electrical sources, and restart the server.
2. If the problem persists, update the Advanced System Management Processor
BIOS. Refer to Chapter 7, “Getting help, service, and information” on page 161
for information about obtaining updates.
If the problem persists, have the system serviced.
1800
A PCI adapter has requested a hardware interrupt that is not available.
Action:
1. Make sure that the PCI adapter and all other adapters are set correctly in the
Configuration/Setup Utility program. If the interrupt resource settings are not
correct, change the settings. For information about using the
Configuration/Setup Utility program, see “PCI Slot/Device Information” on
page 28.
2. If all interrupts are being used by other adapters, you might need to remove an
adapter to make an interrupt available to the PCI adapter, or force other
adapters to share an interrupt. For information about removing adapters, see
“Working with adapters” on page 53. For information about setting interrupts,
see “PCI Slot/Device Information” on page 28.
1962
No valid startup devices were found. The system cannot find the startup drive or
operating system.
Action: Be sure that the drive you want to start from is in the startup sequence.
1. Select Start Options from the Configuration/Setup Utility program main menu.
If you are unable to set the startup sequence, have the system serviced.
2. Check the list of startup devices in the Startup device data fields. Is the drive
you want to start from in the startup sequence?
Yes Exit from this screen; then select Exit Setup to exit from the
Configuration/Setup menu. Go to step 3.
No
Follow the instructions on the screen to add the drive; then save the
changes and exit from the Configuration/Setup menu. Restart the server.
3. Is an operating system installed?
Yes Turn off the server. Go to step 4.
No
Install the operating system in your server; follow your operating system
instructions to shut down and restart the server.
4. During server startup, watch for messages indicating a hardware problem.
If the same error message appears, have the system serviced.
2400
An error occurred during the testing of the video controller on the system board.
This error can be caused by a failing monitor, a failing system board, or a failing
video adapter (if one is installed).
Action: Verify that the monitor is connected correctly to the video connector. If the
monitor is connected correctly, have the system serviced.
2462
A video memory configuration error occurred.
Action: Make sure that the monitor cables are correctly and securely connected to
the server.
If the problem persists, have the system serviced.
118
IBM xSeries User's Reference
Summary of Contents for eServer 240 xSeries
