NDIS 2.01 (OS/2) device driver messages
This section contains the error messages for the NDIS 2.01 (OS/2) device drivers.
The explanation and recommended action are included with each message.
PCNTND-1
Unable to open the Protocol Manager.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-6
Out of memory while allocating buffers.
Explanation: The device driver could not allocate the requested buffers.
Action: Check your system configuration. Edit the PROTOCOL.INI file to reduce the number of
Txbuffers and Rxbuffers specified for the device driver.
PCNTND-7
A Protocol Manager device error occurred.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-8
Bad status for the Protocol Manager.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-9
Cannot find the PROTOCOL.INI entry.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-11 Protocol Manager registration failed.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-15 Device not found.
Explanation: The device driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The device driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
PCNTND-21 The adapter failed the checksum test.
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
Chapter 6. Solving problems
139
Summary of Contents for eServer 240 xSeries
