UNIX messages
This section contains the error messages for the SCO UNIX LLI device driver.
pnt0-2
PCI search specified, PCI device not found!
Explanation: The device driver cannot locate the Ethernet controller on the PCI bus.
Action: Run the NETCONFIG program to search for another Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
pnt0-6
Cannot allocate memory for the adapter during an interrupt. Please check your
Streams parameters.
Explanation: On a SunSoft Solaris system, this message indicates that the system is out of Streams
memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
Modify the interrupt request (IRQ) settings in the Configuration/Setup Utility program, or run the
NETCONFIG program to match the hardware settings.
pnt0-7
Cannot allocate memory for the adapter during reset. Please check your Streams
parameters.
Explanation: The system is out of Streams memory blocks.
Action: Use the CRASH utility to increase the number of Streams memory blocks.
pnt0-11
Device not found!
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
pnt0-12
Device failed checksum test!
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
pnt0-13
add_intr_handler failed! Interrupts already enabled.
Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts with
other devices in the server.
Action: Modify your hardware settings.
Run the NETCONFIG program to match the hardware settings.
pnt0-14
Cannot locate hardware.
Explanation: The SunSoft Solaris device driver cannot find any Ethernet controller.
Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)
If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnostic
programs.
pnt0-15
No more devices to open.
Explanation: The SunSoft Solaris device driver cannot find any more Ethernet controllers.
Action: Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are present or replace the
Ethernet adapter that fails to respond. If the problem persists, go to “Diagnostic programs” on page 110
to run the diagnostic programs.
Chapter 6. Solving problems
141
Summary of Contents for eServer 240 xSeries
