Non-hot-swap options
1. Unlock and open the server door.
7
CAUTION:
If the device has doors, be sure to remove or secure the doors
before moving or lifting the device to avoid personal injury. The
doors will not support the weight of the device.
2. Remove all media (diskettes, CDs, optical discs, or tapes) from the drives; then,
turn off the server and all attached options.
3. Unplug all power cords (cables) from electrical outlets.
4. Note the location of the remaining cables and cords; then disconnect them from
the back of the server.
If you are:
Installing or removing a non-hot-plug adapter, go to “Working with adapters” on
page 53.
Installing or removing a microprocessor, go to “Installing a microprocessor kit”
on page 62.
Installing or removing a memory-module kit, go to “Installing memory-module
kits” on page 65.
Installing or removing a drive in a non-hot-swap drive bay, go to “Installing
internal drives” on page 67.
Chapter 4. Installing options
47
Summary of Contents for eServer 240 xSeries
