144
IBM® xSeries 250: User’s Reference
5.
Remove adapters as necessary, so that you can access the battery. (See “Working
with adapters” on page 41).
6.
Lift and remove the plastic dividers by pressing the latches on the top ends of the
dividers toward the dividers and lifting the dividers from the server.
7.
Remove the battery:
a.
Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery toward the rear of the server. The
spring mechanism behind the battery will push it out toward you as you slide
it forward.
c.
Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
8.
Insert the new battery:
a.
Tilt the battery so that you can insert it into the front of the socket, under the
battery clip.
b. As you slide it under the battery clip, press the battery down into the socket.
9.
Reinstall any adapters that you removed.
10. Insert the plastic dividers into the divider guides.
11. Reinstall the top cover.
Note:
You must wait approximately 20 seconds after you plug the power cord of
your server into an electrical outlet before the power control button
becomes active.
12. Start the Configuration/Setup Utility program and set configuration parameters
as needed. See “Starting the Configuration/Setup Utility program” on page 13.
Summary of Contents for eServer 250 xSeries
