Refer to the following illustration while performing the steps in this procedure.
Notes:
1. The illustrations in this section might differ slightly from your hardware.
2. You do not need to turn off the power to the server to replace hot-swap power
supplies.
1
Handle release latch
2
Power supply
3
Handle
To replace a hot-swap power supply:
1. Remove the power supply:
a. Unplug the power cord from the power supply and the electrical outlet and,
if necessary, remove the power supply cord from the strain-relief bracket.
b. If a strain-relief bracket is attached to the power supply, remove the screw
on the back of the power supply (lower right side), and remove the
strain-relief bracket.
c. Press the release latch
1
on the handle
3
on the power supply
2
.
d. Lift and fully extend the handle on the power supply. Then, slide the power
supply out of the chassis. Refer to your power supply option
documentation for complete instructions on proper handling and disposal of
a defective power supply.
86
xSeries 370 User's Reference
Summary of Contents for eServer 370 xSeries
