2. Replace the power supply:
a. Touch the static-protective package containing the power supply to any
unpainted metal surface on the server. Then, remove the power supply
from the static-protective package.
b. Place the power supply handle
3
in the open (up) position, and slide the
power supply into the chassis. If necessary, lower the handle slightly to
avoid the I/O housing assembly; then, continue inserting the power supply
into the bay until it stops.
c. Press the handle down to seat the power supply in the bay. This places
the power supply in the locked position.
d. Reconnect the power cord to the power supply and the electrical outlet (if
removed).
e. Remove the new strain-relief bracket from its package and install it on the
power supply cord.
Note:
If a new strain-relief bracket did not come with your new power
supply, attach the strain-relief bracket that you removed in step 1b
on page 86 on the new power supply.
f. Verify that the ac power light and the dc power light are lit, indicating that
the power supply is operating correctly. See “Power supply LEDs” on
page 156 for details. See “Power supplies” on page 13 for the location of
the ac and dc power LEDs.
3. If you have other options to install or remove, do so now; otherwise, continue
with “Completing the installation” on page 90.
Chapter 4. Installing options
87
Summary of Contents for eServer 370 xSeries
