To replace the battery:
1. Turn off the server and peripheral devices, and disconnect all external cables
and power cords (see “Preparing to install options” on page 48); then, remove
the top cover (see “Removing the top cover” on page 49).
2. Remove the I/O function card from the server:
a. Refer to the following illustration while you perform the steps in this
procedure.
b. Disconnect all cables
1
from the I/O function card
2
. Note carefully
where each cable is connected before you remove it. See “I/O function
card component locations” on page 103 for the connector locations on the
I/O function card.
c. Remove the two screws
4
located on the metal connector plate inside the
server.
d. Remove the I/O function card retention bracket
3
on the right side of the
card by pulling out the fastener on the bracket.
e. Carefully grasp the I/O function card by its top edge and pull the I/O
function card out of the server.
f. Place the I/O function card connector-side up on a flat, static-protective
surface.
3. Locate the battery on the I/O function card (see “I/O function card component
locations” on page 103).
160
xSeries 370 User's Reference
Summary of Contents for eServer 370 xSeries
