4. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery toward the rear of the I/O
function card. The spring mechanism behind the battery will push it out
toward you as you slide it forward.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
5. Insert the new battery:
a. Tilt the battery so that you can insert it into the front of the socket, under
the battery clip.
b. As you slide it under the battery clip, press the battery down into the
socket.
6. Install the I/O function card:
a. Refer to the illustration in step 2a on page 160 while you perform the steps
in this procedure.
b. Carefully grasp the I/O function card by its top edge, and insert the tabs on
the bottom edge of the metal connector plate in the matching openings on
the server back panel.
c. Align the I/O function card with the guide on the opposite end of the
adapter and the slot on the I/O board.
d. Press the I/O function card
firmly
into the slot.
Attention:
When you install the I/O function card in the server, be sure
that it is completely and correctly seated. Incomplete insertion might cause
damage to server components.
e. Reinstall the I/O function card retention bracket that you removed in step
2d on page 160 by pressing in the fastener on the bracket.
f. Insert the two screws that you removed in step 2c on page 160.
Chapter 6. Solving problems
161
Summary of Contents for eServer 370 xSeries
