Removing the processor housing assembly
To remove the processor housing assembly:
1. Read “Safety information” on page 39 through “Handling static-sensitive
devices” on page 43.
2. Run the shutdown procedure for the operating system. Turn off the server and
peripheral devices, and disconnect all external cables and power cords (see
“Preparing to install options” on page 48); then, remove the front bezel (see
“Removing the front bezel” on page 50).
3. Remove the three processor fans:
a. Pull the fastener
1
in the top center of the fan housing
2
. This places
the fastener in the unlocked position.
b. Pivot the fan downward and remove it from the server.
c. Repeat steps 3a and 3b for each additional fan.
Refer to the following illustration while you perform the steps in this section.
4. Open the two latches
1
at the top of the processor housing assembly
2
.
Fully extend the latches.
58
xSeries 370 User's Reference
Summary of Contents for eServer 370 xSeries
