5. Pull the processor housing assembly partially out of the server, approximately
203.2 mm (8 in.).
Attention:
To avoid injury, do not place your fingers immediately behind the
latches at the top of the processor housing assembly.
6. Close the latches at the top of the processor housing assembly.
Attention:
Do not lift the processor housing assembly by the latches.
7. Grasp the bottom sides of the processor housing assembly. Lift and slide the
assembly out of the server until it stops, approximately 228.6 mm (9 in.); then,
lift the assembly slightly and remove it from the server.
Note:
If the assembly stops before you can slide it out of the server, lift it
slightly and continue to remove it from the server.
8. Place the processor housing assembly on a flat, static-protective surface, with
processor labels A1–A4 and B1–B4 right side up.
Chapter 4. Installing options
59
Summary of Contents for eServer 370 xSeries
