The following procedure describes the cable routing that is necessary when you
install the ServeRAID adapter. Refer to the following illustration while you perform
the steps in this procedure.
Note:
It might be easier for you to route the cable before you install the adapter.
1
Standard internal SCSI cable location for connection to internal SCSI port B
2
Internal SCSI port B
3
New internal SCSI cable location for connection to ServeRAID adapter
1. Read “Safety information” on page 39 through “Working inside a server with
power on” on page 44.
2. Disconnect the internal SCSI cable
1
from internal SCSI port B
2
on the I/O
function card.
3. Change the setting of the three-pin, SCSI B detect jumper (identifier J19) on
the I/O function card from pins 1 and 2 to pins 2 and 3. This prevents the
server from displaying a non-applicable error message,
Cable not present
.
1 2 3
Note:
For additional information on changing jumper settings, see “Changing
jumper settings” on page 111. For the jumper location, see the
illustration of the I/O function card in “I/O function card component
locations” on page 103.
Chapter 4. Installing options
77
Summary of Contents for eServer 370 xSeries
