7. Install the microprocessor:
Attention:
v
Do not use excessive force when pressing the microprocessor into the
socket.
v
Make sure that the microprocessor is oriented and aligned correctly with pin
number 1 in the socket before you try to close the lever. The following
illustration shows the alignment marks for microprocessor 2 and
microprocessor socket 2.
a. Center the microprocessor over the microprocessor socket. Align the
triangle on the corner of the microprocessor with the triangle on the corner
of the socket and carefully press the microprocessor into the socket.
Microprocessor 2
Microprocessor
socket 2
Alignment marks
b. Carefully close the microprocessor-release lever to secure the
microprocessor in the socket.
8. Install a heat sink on the microprocessor:
Attention:
v
Do not set the heat sink down after you remove the plastic cover.
Heat sink
Thermal grease
v
Do not touch the thermal grease on the bottom of the heat sink. Touching
the thermal grease will contaminate it. If the thermal grease on the
microprocessor or heat sink becomes contaminated, contact your service
technician.
a. Remove the plastic protective cover from the bottom of the heat sink.
b. Align and place the heat sink on top of the microprocessor with the thermal
grease side down. Press firmly on the heat sink.
Attention:
If you do not alternate the tightening of the two captive
screws, you might damage the microprocessor. Ensure that the screws are
completely tightened; otherwise, the server will not function properly.
c. Secure the heat sink to the microprocessor by tightening the captive
screws. Alternate between the two captive screws in the heat sink while
tightening them.
9. Install the air baffle.
10. If you have other options to install or remove, do so now; otherwise, go to
“Completing the installation” on page 17.
Chapter 2. Installing options
15
Summary of Contents for eServer xSeries 345 Type 8670
