5.
When the prompt
Press <F1> Setup
is displayed, press F1. If you have set an
administrator password, you must type the administrator password to access
the full Setup-utility menu. If you do not type the administrator password, a
limited Setup-utility menu is available.
6.
Select
System Settings
and then press Enter.
7.
Select
Devices and I/O Ports
and then press Enter.
8.
Select
Console Redirection Settings
and then press Enter.
9.
From the Console Redirection Settings menu:
a.
If you are using a serial breakout cable with a BladeCenter H unit or a
BladeCenter S unit, set
COM Port 1
to
Enable
; otherwise, set it to
Disable
.
b.
Set
COM Port 2
to
Enable
.
c.
Set
Remote Console
to
Enable
.
d.
Set
Legacy Option ROM Display
to
COM Port 2
.
e.
Set the following
COM2 Settings
:
1)
Make sure that the
Baud Rate
is set to
115200
.
Note:
The settings for
Data Bits
,
Parity
, and
Stop Bits
are static and
cannot be changed.
2)
Set
Terminal Emulation
to
ANSI
(default) or
VT100
, depending on
your system configuration.
3)
Set
Active After Boot
to
Enable
.
4)
Set
Flow Control
to
Hardware
.
26
BladeCenter: Serial over LAN Setup Guide
Summary of Contents for HS40 - BladeCenter - 8839
