Thumbscrew
Retention
brackets
Network
adapter
Captive screws
Network
adapter
connector
screws
Pin
7. Press the adapter firmly until the pin, and retention brackets engage the
adapter. Make sure the adapter is securely seated on the connector on the
planar.
Attention:
Make sure the port connectors on the adapter are aligned properly
with the chassis on the rear of the server. An incorrectly seated adapter might
cause damage to the system board or the adapter.
8. Fasten the screws and the captive screws on the network adapter.
9. Fasten the thumbscrew on the rear of the chassis.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation.”
Completing the installation
To complete the installation, complete the following tasks. Instructions for each task
are in one of the following sections.
1. Install the system-board tray cover (see “Reinstalling the system-board tray
2. Install the system-board tray in the chassis (see “Reinstalling a system-board
tray in a 2U chassis” on page 37).
3. Connect the cables. For more information, see “Connecting the cables” on page
4. For some devices, run the server Setup utility. For more information, see
“Updating the server configuration” on page 38.
5. (IBM Business Partners only) Complete the additional steps in “Instructions for
IBM Business Partners” on page 23.
Reinstalling the system-board tray cover
Attention:
You cannot insert the system-board tray into a chassis until the cover
is installed and closed. Do not attempt to override this protection.
36
System x iDataPlex dx360 M4 Types 7918 and 7919: User’s Guide
Summary of Contents for iDataPlex dx360 M4
