Chapter 4. Configuring the server
The following configuration programs come with the server:
v
Setup utility
The UEFI (formerly BIOS) Setup Utility program is part of the basic input/output
system firmware. Use it to change interrupt request (IRQ) settings, change the
startup-device sequence, set the date and time, and set passwords. For
information about using this program, see “Using the Setup utility” on page 42.
v
Boot Manager program
The Boot Manager program is part of the server firmware. Use it to override the
startup sequence that is set in the Setup utility and temporarily assign a device to
be first in the startup sequence. For more information about using this program,
see “Using the Boot Manager program” on page 47.
v
IBM
ServerGuide Setup and Installation
CD
The ServerGuide program provides software-setup tools and installation tools
that are designed for the server. Use this CD during the installation of the server
to configure basic hardware features, such as an integrated SAS/SATA controller
with RAID capabilities, and to simplify the installation of your operating system.
For information about using this CD, see “Using the ServerGuide Setup and
Installation CD.”
v
Integrated Management Module II
Use the integrated management module II (IMM2) for configuration, to update the
firmware and sensor data record/field replaceable unit (SDR/FRU) data, and to
remotely manage a network. For information about using the IMM2, see “Using
the integrated management module II” on page 47.
v
VMware ESXi embedded hypervisor
The VMware ESXi embedded hypervisor is available on the server models that
come with an installed USB embedded hypervisor flash device. The USB flash
device is installed in the USB connector on the system board. Hypervisor is
virtualization software that enables multiple operating systems to run on a host
system at the same time. For more information about using the embedded
hypervisor, see “Using the embedded hypervisor” on page 50.
v
Ethernet controller configuration
For information about configuring the Ethernet controller, see “Configuring the
Gigabit Ethernet controller” on page 50.
v
IBM Advanced Settings Utility (ASU) program
Use this program as an alternative to the Setup utility for modifying UEFI
settings. Use the ASU program online or out of band to modify UEFI settings
from the command line without the need to restart the server to access the Setup
utility. For more information about using this program, see “IBM Advanced
Settings Utility program” on page 53.
Using the ServerGuide Setup and Installation CD
The
ServerGuide Setup and Installation
CD provides software setup tools and
installation tools that are designed for your server. The ServerGuide program
detects the server model and hardware options that are installed and uses that
information during setup to configure the hardware. Use this CD during the initial
installation of the server to simplify the operating-system installations by providing
updated device drivers and, in some cases, installing them automatically. To
© Copyright IBM Corp. 2012
39
Summary of Contents for iDataPlex dx360 M4
