Installing memory
Installing a firmware
card
Installing an option card
1
Unpack the memory option.
2
Open both latches on the connector.
3
Push the memory card firmly into the connector until it
snaps
into place.
1
Locate the holes on the system board near the option card
connectors.
2
Unpack the firmware card.
3
Holding the firmware card by its sides, align the two pins on the
card with the holes on the system board.
4
Push in until the firmware card is firmly in place.
1
Locate the card connectors on the system board. If you are
installing only one card, install it in connector 1.
2
Locate the two screws on the back of the printer that attach the
metal plate to the slot.
3
Remove and save the two screws, and then remove and
discard the plate.
4
Unpack the card.
5
Align the connection points on the card with the connector on
the system board and push the card firmly into the system
board connector.
Assemble paper handling options
15
Summary of Contents for Infoprint M22 MFP
