v
For Models 830 and SB2, see Locations -- Models 830, SB2 System Unit with
FC 9074 Base I/O Tower.
v
For Models 840 and SB3, see Locations -- Models 840, SB3 System Unit with
Processor Tower and FC 9079 Base I/O Tower.
Did this fix the problem?
v
Yes
:
This ends the procedure.
v
No
: Exchange the Tower Card in position CB1. To determine CCIN, part
number, and removal and installation procedure, locate card position CB1
and FRU name
″
Tower Card
″
from the following:
– For Model 830, SB2 see Locations -- Models 830, SB2 System Unit with FC
– For Model 840, SB3 see Locations -- Models 840, SB3 System Unit with
Processor Tower and FC 9079 Base I/O Tower.
If the problem still has not been fixed, contact your next level of support.
This ends the procedure.
8.
Is the reference code B4FF00B3?
v
No
: Contact your next level of support.
This ends the procedure.
v
Yes
: Continue with the next step.
9.
Choose one of the following:
v
The system cannot find any processors. If you are working on a Model 830
or a Model 840, the PCI drawer may be the failing item. See Symbolic FRU
TWRPLNR . If that fails to correct the problem, exchange the J-Tag cable. See
the Power and Signal cables table for the system on which you are working.
If that fails to correct the problem, any processor may be the failing item.
Refer to Symbolic FRU ANYPROC for the procedure to determine processor
location and part information.
v
For system Models 830 and SB2:
The Clock card in location M06A may be
the failing item. To determine the CCIN, part number, and removal and
installation procedure, locate card position M06A and FRU name
″
Clock
Card
″
in Locations -- Models 830, SB2 System Unit with FC 9074 Base I/O
Tower. Exchange the failing item.
Did this fix the problem?
–
Yes
:
This ends the procedure.
–
No
: Exchange the network interface controller (NIC) card. To determine
the CCIN, part number, and removal and installation procedure, locate
card position M06 and FRU name
″
network interface controller (NIC)
card
″
in Locations -- Models 830, SB2 System Unit with FC 9074 Base I/O
Tower.
If the problem still is not fixed, contact your next level of support.
This ends the procedure.
v
For system Models 840 and SB3:
The network interface controller (NIC) card
in location M17 may be the failing item. To determine the CCIN, part
number, and removal and installation procedure, locate card position M17
and FRU name
″
network interface controller (NIC) card
″
in Locations --
Models 840, SB3 System Unit with Processor Tower and FC 9079 Base I/O
Tower. Exchange the failing item.
If this did not fix the problem, contact your next level of support.
This ends the procedure.
B4FF
260
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference
Codes)
