Reference Code
Description/Action Perform all actions before exchanging Failing Items
Failing Item
9289
Invalid Packet Length for data sent.
Invalid Packet Length occurred for data exchanged.
AJDG301
TWRCARD
C62E
SPCN Network Fault
An SPCN frame-to-frame communication failure was detected.
CB15
EEPROM Failure
Table 2. SPCN failing items for Models 800, 810, and 825
Failing Item
Description
Document Description
ACMODUL
AC Module
Problem Analysis; Symbolic FRU Isolation
AIRMOVR
Fan and Blower assemblies
Problem Analysis; Symbolic FRU Isolation
AJDG301
Vertical Licensed Internal Code.
Service Functions; APAR or LICTR
ALTMANL
Alternate Manual Required
Problem Analysis; Symbolic FRU Isolation
BACKPLN
Back Plane Unit
Problem Analysis; Symbolic FRU Isolation
BATCHGR
Battery Power Unit Charger
Problem Analysis; Symbolic FRU Isolation
BATRY
Battery Power Unit
Problem Analysis; Symbolic FRU Isolation
CBLALL
Cable Failure
Problem Analysis; Symbolic FRU Isolation
CTLPNL
Control Panel
Problem Analysis; Symbolic FRU Isolation
I2CBUS
I2C Bus Part
Problem Analysis; Symbolic FRU Isolation
IDPART
Vital Product Data Parts
Problem Analysis; Symbolic FRU Isolation
PGDPART
Power Good Part
Problem Analysis; Symbolic FRU Isolation
PWROC
Power Supply overcurrent
Problem Analysis; Symbolic FRU Isolation
PWRREG
Regulator.
Problem Analysis; Symbolic FRU Isolation
PWRSPLY
Power Supply
Problem Analysis; Symbolic FRU Isolation
SVCPROC
Service Processor Card
Problem Analysis; Symbolic FRU Isolation
TWRCARD
Card enclosure or backplane
Problem Analysis; Symbolic FRU Isolation
UPSUNIT
UPS unit part
Problem Analysis; Symbolic FRU Isolation
VPDPART
VPD Communication Part
Problem Analysis; Symbolic FRU Isolation
(1xxx) SPCN Reference Codes for Models 830, 840, SB2, and SB3
For details on the Failing Item column entries, see the SPCN Failing Items Detail
table, which follows the Reference Code table below.
Note:
On Models 840/SB3, the C in the SRC (1xxC xxxx) indicates that the failure
is on the processor frame, not on the FC 9079 Base I/O Tower.
Table 1. SPCN reference codes for Models 830, 840, SB2, and SB3
:
1xxx
68
iSeries: iSeries 270, 800, 810, 820, 825, 830, 840, 870, 890, SB2, and SB3 Analyze Hardware Problems (System Reference Codes)
