Removing and replacing Tier 1 CRUs
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
SCSI hard disk drive
To remove a SCSI hard disk drive, complete the following steps:
SCSI ID 1
SCSI ID 0
Hard drive
release lever
Hard drive
release lever
1. Read the safety information that begins on page v and “Installation guidelines”
on page 59.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit. See “Removing and installing the blade
server in a BladeCenter unit” on page 61 for instructions.
3. Carefully lay the blade server on a flat, non-conductive surface.
4. Remove the blade server cover (see “Operating the blade server cover” on
page 64 for instructions).
5. Locate the hard disk drive to be removed (SCSI ID 0 or SCSI ID 1).
6. While pulling the blue release lever at the front of the hard disk drive tray, slide
the drive out of the SCSI connector and disengage it from the drive tray.
Chapter 4. Removing and replacing blade server components
67
Summary of Contents for LS20 - BladeCenter - 8850
