2 Loading Pre-Configuration
1. Insert the SE-RESTORE1 diskette into
drive
A:
.
2. ENTER
A:
to make the
A:
drive the
current drive.
3. ENTER
LOADRAM E:XXXX.C C: /C/M/S/NE
(Where XXXX equals the EIA location for
the CPC EXAMPLE=A18A.
4. ENTER
LOADRAM C:IQYBCBK1.RAM C:
/C/M/S/NE
(Where XXXX equals the EIA
location for the CPC EXAMPLE=A18A.
5. ENTER
LOADRAM C:IQYBFBKP.RAM F:
/C/M/S/NE
(Where XXXX equals the EIA
location for the CPC EXAMPLE=A18A.
6. ENTER
LOADRAM E:XXXX.D D: /C/M/S/NE
(Where XXXX equals the EIA location for
the CPC EXAMPLE=A18A.
3 Clean-up
1. ENTER
ERASE E:\*.*
2. ENTER
ERASE C:\*.RAM
3. Remove the SE-RESTORE1 diskette from
the Support Element drive
A:
.
4. Press
ALT+CTRL+DELETE
to re-boot the
Support Element
Note:
Repeat this procedure on the Support
Element associated with the next CPC on
the
CPC LOCATIONS
diskette label.
Continue to repeat this procedure until all
Support Element associated with the CPC
listed on the
CPC LOCATIONS
diskette
have been configured.
4 Completing the Installation
1. When all Support Element associated with
the CPC's listed on the CPC LOCATIONS
DISKETTE have been configured the CPC
will be left in a undefined state to the
Hardware Management Console it will be
necessary to go to “Defining Support
Element to the Hardware Management
Console” on page 6-10 to define the
Support Element to the Hardware
Management Console
6-68
Installing the System
Summary of Contents for Multiprise 3000 S/390
