Select this choice to view or change the settings for
advanced configuration options. These options
include enabling support for large hard disk drives
and support for drives with &ultra. speed.
To reset the SCSI controller defaults, press F6; then,
follow the instructions on the screen.
SCSI Disk Utilities:
To see the IDs that are assigned
to each SCSI device or to format a SCSI device, select
SCSI Disk Utilities from the SCSISelect Utility program
menu.
To use the utility program, select a drive from the list.
Read the screens carefully before you make a selection.
Note
If you see the following message, you might have
pressed Ctrl
+
A before the selected drives were ready.
Restart the server, and watch the SCSISelect
messages as each drive spins up. After the drive that
you want to view or format spins up, press Ctrl
+
A.
à
ð
Unexpected SCSI Command Failure
Target SCSI ID:
4
SCSI CDB Sent:
ð3 ðð ðð ðð ðE ðð ð7 ðð ð2 ðð
Host Adapter Status:
ððh - No host adapter error
Target Status:
ð2h - Check condition
Sense Key:
ð2h - Not ready
+Sense Code:
ð4h
+Sense Code Qualifier:
ð2h
Press 'Esc' to continue.
á
ñ
Performing a Low-Level Disk Format:
You can
use the
Format Disk feature of the SCSISelect Utility
program to perform a low-level format on hard disks.
Depending on the hard disk capacity, the low-level format
program could take up to two hours.
When To Use the Format Disk Program:
Use the
Format Disk program:
When you are installing software that requires a
low-level format
When you get recurring messages from the diagnostic
tests directing you to run the Low-Level Format
program on the hard disk
44
IBM Netfinity Servers HMM
Summary of Contents for Netfinity 3500 Series
