Installing the Rack Model in a Rack Enclosure
Installing the Rack Model in a Rack Enclosure
During this procedure, you must install parts on the rack enclosure and the server.
This process can be divided into three parts:
Preparing the server
Preparing the rack enclosure
Installing the server into the rack enclosure
Before you begin
Read “Electrical Safety” on page 41 and “Handling Static-Sensitive Devices”
on page 42, and the safety information in your rack enclosure
documentation.
Turn off the server, if it is on.
Refer to your rack enclosure documentation for additional information on
preparing the rack.
Preparing the Server
In this section, you will use the following parts:
One cable arm bracket
The inner slide from two slide bracket assemblies
6 pan-head short screws (M4 by 5 mm)
5
CAUTION:
Use safe lifting practices when lifting your machine.
Attention:
To avoid damage to internal components, use only the pan-head short screws (M4
by 5 mm) included with the Rack Mount Kit.
k
32 kg (70.5 lbs)
k
55 kg (121.2 lbs)
96
Netfinity 5000 Server Hardware Information and Procedures
