Appendix B. Upgrading memory
See “Resolving hardware problems” on page 11 to determine whether or not it is necessary to replace the logic unit,
or any other parts. For information on ordering thin client hardware parts, refer to “Replacing additional parts” on
page 27.
Read “Safety notices” on page v before you continue with these instructions.
Note:
The thin client shown in these procedures is an Exx Model.
Removing the logic unit
Read “Safety notices” on page v before you continue with
these instructions.
1.
Power off the thin client, and disconnect all cables to
the thin client.
2.
Remove the two thumbscrews
A
at the back of the
logic unit.
3.
Push the logic unit
B
out of the cover.
4.
Lay the logic unit on a flat surface.
5.
Continue with “Installing a memory card” to install a
memory card.
Installing a memory card
Complete the instructions in “Removing the logic unit”,
and read “Safety notices” on page v before you continue
with these instructions.
1.
To remove a previously installed memory card, press
the tabs
A
, that are located at each end of the
memory card
B
, out until the memory card
B
comes out of the memory socket
C
.
2.
To install a memory card, align the notches on the
bottom of the memory card
B
with the matching
notches on the memory socket
C
.
3.
Press the memory card down into the memory socket
C
. The tabs
A
should swing in, holding the
memory card in place.
4.
Continue with “Reassembling the Network Station”
© Copyright IBM Corp. 2000
31
