Appendix C. CompactFlash card
Follow these steps to verify if the CompactFlash card is installed properly.
Read “Safety notices” on page v before you continue with these instructions.
Note:
The thin client shown in these procedures is an Exx Model.
1.
Perform Steps 1 to 4 in “Removing the logic unit” on
page 31.
2.
Align the grooves on the sides of the CompactFlash
card
A
to the grooves of the flash card slot
B
.
Make sure to align the grooves properly, as you can
insert the CompactFlash card only one way.
3.
Carefully press the CompactFlash card into the flash
card slot. To avoid hardware damage, do not force the
card into the flash card slot.
4.
Perform “Reassembling the Network Station” on
page 32.
© Copyright IBM Corp. 2000
33