Error 107 indicates that the cable from the LAN is not securely connected to the
Ethernet port on your computer. Check the cable to ensure that it is properly
connected.
Other error messages that might occur are shown in the following table.
Table 7. Ethernet error messages
RPL-ROM-ERR: 100 The Ethernet adapter cannot be found.
RPL-ROM-ERR: 101 The Ethernet adapter was unable to initialize.
RPL-ROM-ERR: 102 The Ethernet adapter could not be reset. 78 User Guide
RPL-ROM-ERR: 103 There are multiple Ethernet adapters in the system. Specify the correct
serial number in NET.CFG.
RPL-ROM-ERR: 104 The Ethernet adapter EEPROM is faulty or not present.
RPL-ROM-ERR: 106 The Ethernet adapter is configured for Plug and Play in a non-Plug
and Play system.
RPL-ROM-ERR: 110 The Ethernet adapter RAM failed the memory test.
DHCP-related error messages
Error messages related to DHCP and the Ethernet adapter are shown in the
following table.
Table 8. DCHP-related error messages
E61: Service boot canceled.
E62: Cannot initialize controller.
E63: Cannot initialize controller.
E67: Cannot initialize controller.
E6d Cannot find BOOTP server.
E6e: Cannot start from downloaded image.
E71: Too many MTFTP packages.
M10: ARP canceled by keystroke.
M11: ARP timeout.
M20: Cannot copy memory.
M21: Cannot write to memory.
M22: Cannot write to memory.
M30: Cannot ARP TFTP address.
M31: TFTP canceled by keystroke.
M32: TFTP open timeout.
M33: Unknown TFTP opcode.
M34: TFTP read canceled by keystroke.
M35: TFTP timeout.
M38: Cannot open TFTP connection.
M39: Cannot read from TFTP connection
M40: BOOTP canceled by keystroke.
M40: DHCP canceled by keystroke.
M41: BOOTP timeout.
32