Chapter 1. Setting up your hardware
Unpacking your hardware
Unpack your hardware. Contact your reseller, or
IBM, if you do not have these standard parts:
1
Network Station
2
Base
3
Mouse
4
Keyboard
5
Power cable
Selecting the voltage for your location:
Attention:
You may damage the Network
Station if you do not select the correct voltage.
1.
Locate the voltage switch
A
on the bottom of
the Network Station.
2.
Use a pen, or similar object, to slide the switch
A
to the correct setting for your location (see
″
Voltage selection
″
Installing options:
v
If you have additional memory, or optional
feature cards, see Chapter 2 before continuing
with the following setup procedures.
v
If you have a security cable and would like to
restrict access to the Network Station logic unit,
thread your cable through hole
B
.
v
For vertical placement of the Network Station,
see “Installing the support base” on page 2.
v
For horizontal placement of the hardware,
continue with “Connecting your hardware” on
page 2.
© Copyright IBM Corp. 1999
1
Summary of Contents for Network Station E Series
