Installing the support base
Slide the base
B
onto the notched bottom of the
Network Station
A
until it latches securely.
Connecting your hardware
Read “Safety and environmental notices” on page v
before continuing.
1.
Connect the devices listed below to the
appropriate ports:
1
USB devices
2
Network cable
3
Serial device 2
4
Serial device 1
5
Parallel devices
6
Monitor
7
Mouse
8
Keyboard
13
Headphones
14
Microphone
2.
Tighten all device cable connections.
3.
Connect the Network Station power cable to the
power socket
10
.
4.
Plug all power cables into properly grounded
working electrical outlets.
5.
To power on your Network Station, move the
power supply switch
9
to the
″
on
″
position.
Notes:
a.
The white power switch
11
resets the
power to your Network Station.
b.
The system LED
12
should flash from
amber to green. See Chapter 3 for
deviations.
6.
Choose the operating system for your server
from the menu that appears on your screen.
Refer to the server software information to
verify the correct selection for your network.
Note:
If your Network Station is unable to
receive the operating system code from the
server, contact your network administrator.
2
IBM Network Station
Summary of Contents for Network Station E Series
