Chapter 2. Installing the battery, memory, and optional
cards
Removing the logic unit to install parts
Read Safety and environmental notices, and
“Handling static-sensitive devices” on page vi before
continuing.
1.
Turn off the power supply switch
A
.
2.
Disconnect all cables from the Network Station.
3.
Hold the Network Station cover assembly, lift
latch
B
, and pull the logic unit
C
out.
4.
Carefully lay the logic unit down with the
internal components facing up. You are now
ready to perform the installation procedures
provided in this chapter.
5.
Complete the procedure, “Reassembling the
Network Station” when you are finished
installing components in the logic unit.
Reassembling the Network Station
Read Safety and environmental notices, and
“Handling static-sensitive devices” on page vi before
continuing.
1.
To reassemble the Network Station, carefully slide
the logic unit
C
into the cover assembly while
depressing the slide stop
D
.
2.
Slide the logic unit completely into the cover
assembly, until the latch
B
is engaged.
3.
Perform steps 1 through 5 of the procedure,
“Connecting your hardware” on page 2.
© Copyright IBM Corp. 1999
3
Summary of Contents for Network Station E Series
