Installing a 3.5-Inch Drive in the 3-Bay Design
Note:
Since the 3-bay design comes with the internal drives already installed in
both 3.5-inch drive bays, this section includes instructions for the removal of
a drive and replacing it with a new drive.
Before you begin
Read “Electrical Safety” on page 3 and “Handling Static-Sensitive Devices”
on page 4.
Read the instructions that come with the drive you want to install or replace.
Turn off the computer and all other connected devices.
Disconnect all cables attached to the computer and remove the computer
cover (see “Disconnecting Cables and Removing the Cover” on page 5).
Determine which drive bay you will use. If you want to use bay 2, go to
“Installing a Drive in Bay 2” on page 42. If you want to use bay 3, go to
“Installing a Drive in Bay 3” on page 45. To locate the different bays, see
page 36.
Chapter 5. Working with Internal Drives
41
