Security Procedures
2. To change the jumper setting:
a. Lift the jumper straight up off the pin block.
b. Align the holes in the bottom of the jumper with the center
pin and the pin that was not covered previously.
c. Slide the jumper down over these pins.
3. Set the jumper to the desired position:
To set the administrator password to the change state, move
the jumper to position 0.
To set the administrator password to the locked state, move
the jumper to position 1.
What to do next?
Setting a new administrator password? — Reinstall the cover as
described under “Completing the Installation” on page 289;
then go to the instructions in “Defining System Security” on
page 155.
Adding or changing a power-on password? — Go to “Setting a
Power-on Password” on page 159.
Installing a U-bolt? — Go to “Installing a U-Bolt” on page 288.
No internal devices to install or remove? — Go to “Completing
the Installation” on page 289.
Installing an external option? — Go to “Connecting External
Options” on page 293.
Chapter 6. Installing Options
287
Summary of Contents for PC Server 520
