Installing Hot-Swap Power Supplies
To add a power supply, do the following steps:
1. Locate the cover on the power-supply bay (at the back of the
power-supply chassis).
2. Remove the four screws from the cover.
3. Remove the cover from the power-supply bay and save it for
future use.
4. Support the power supply with the handle
.3/
on the back.
5. Slide the new or replacement power supply into the chassis.
6. Install the four screws (
.2/
in the following figure) to secure the
power supply.
7. Connect the power cord to the back of the chassis. A
spring-loaded interlock at the AC receptacle
.1/
prevents the
power supply from being removed unless the power cord has
been removed. Plug the power cord into a properly grounded
electrical outlet.
190
PC Server 704 User's Handbook
