Installing the server into a rack
With the rack installed, you must install your server into the rack and set up the cable-management arm.
Note:
If present, use the rack-mount template to perform these tasks.
Determining the location
You might need to determine where to install the system in the rack. Use this procedure to perform this
task.
Before installing the system unit into a rack, complete the following steps:
1.
Read the Rack safety notices (http://publib.boulder.ibm.com/infocenter/systems/scope/hw/topic/
p7hbf/racksafety.htm).
2.
Plan where to place the units. Place the larger and heavier units in the lower part of the rack.
This system unit is two Electronic Industries Alliance (EIA) units high. An EIA unit is 44.45 mm (1.75
in.) in height. The rack contains three mounting holes for each EIA unit of height. This system unit
therefore is 88.9 mm (3.5 in.) high and covers 6 mounting holes in the rack.
3.
If necessary, remove the filler panels to allow access to the inside of the rack enclosure where you
plan to place the unit, as shown in Figure 1 on page 4.
© Copyright IBM Corp. 2010, 2013
3
Summary of Contents for POWER 730
Page 2: ......
Page 57: ......
Page 58: ...Part Number 00L5066 Printed in USA GI11 9861 03 1P P N 00L5066...
