4.
If necessary, remove the front and rear rack doors.
Marking the location
Learn how to mark the position on the rack for installing the slide rail.
To mark the installation location, complete the following steps:
1.
Facing the front of the rack and working from the right side, locate the bottom EIA unit that your
system will use. Make a note of the EIA location. Use tape, a marker, or a pencil to mark the bottom
hole of this EIA unit as
A
, as shown in Figure 2 on page 5. Mark the rack so that the mark can also be
seen from the rear of the rack.
Note:
Use the marked holes to determine where to locate the slide rails, and attach them by using the
pins.
Figure 1. Removing the filler panels
4
Power Systems: Installing the IBM Power 710 Express (8231-E1C) or IBM Power 730 Express (8231-E2C)
Summary of Contents for POWER 730
Page 2: ......
Page 57: ......
Page 58: ...Part Number 00L5066 Printed in USA GI11 9861 03 1P P N 00L5066...
