Power775 Disk Enclosure Fan Service Procedure
35 of 61
3.8 Install Cam Followers and Slide DE to Service Position <= SSR TASK
STEP 26
Move the Cam Followers from the storage position near EIA 5 in the lowest slot in the frame (see Figure 19 and
20) to the location of the Disk Enclosure with the failed fans.
DANGER:
Risk of injury due to heavy components falling from rack if the supplemental
supports are not installed. (L019)
ATTENTION: The supplemental supports (Cam Followers) must be installed for the CEC or DE
slide out service.
In order to do this, unscrew the shipping screws of the left and right cam followers (see Figure 24) and keep the
screws to reinstall later.
Remove the cam followers from their storage location. The cam followers are removed by pulling out
the plunger and sliding the cam follower up.
Install the cam followers in the frame slot of the Disk Enclosure with the failed fans. Slide the cam
follower hook into the slot so the roller aligns with Disk Enclosure channels, and then insert pin into
frame rail (see Figures 21 to 24).