Power 775 D-Link Service Procedure
PN: 41U8487, EC N44172
13 of 27
STEP 6
In the window titled
Identify LED, Select Enclosure
select
System Unit, Model F2C
then
click
the
Activate
LED
button (see Figure 2). This will cause the CEC ID LED to flash, as well as the UEPO Panel of the frame.
Figure 2 System Unit, Model F2C Selection – Activate LED
STEP 7
Locate the frame. The UEPO Identify Amber Led (see Figure 3) should be flashing. If the LEDs are not flashing,
verify th e FRU via MTMS (machine type model serial number). The rack level MTMS is located on the face of
the UEPO (see Figure 3). Open the front and rear door of the frame.
Identify
Amber
LED
MTMS
Figure 3 UEPO Identify LED location
