IBM Power System 9009-22G Manual Download

Page: 11 / 76

CAUTION: Data processing environments can contain equipment transmitting on system links with

laser modules that operate at greater than Class 1 power levels. For this reason, never look into

the end of an optical fiber cable or open receptacle. Although shining light into one end and looking

into the other end of a disconnected optical fiber to verify the continuity of optic fibers may not

injure the eye, this procedure is potentially dangerous. Therefore, verifying the continuity of optical

fibers by shining light into one end and looking at the other end is not recommended. To verify

continuity of a fiber optic cable, use an optical light source and power meter. (C027)
CAUTION: This product contains a Class 1M laser. Do not view directly with optical instruments.

(C028)
CAUTION: Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the

following information:
• Laser radiation when open.
• Do not stare into the beam, do not view directly with optical instruments, and avoid direct

exposure to the beam. (C030)

(C030)
CAUTION: The battery contains lithium. To avoid possible explosion, do not burn or charge the

battery.
Do Not:
• Throw or immerse into water
• Heat to more than 100 degrees C (212 degrees F)
• Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the battery as instructed by

local regulations. In the United States, IBM has a process for the collection of this battery. For

information, call 1-800-426-4333. Have the IBM part number for the battery unit available when

you call. (C003)
CAUTION: Regarding IBM provided VENDOR LIFT TOOL:
• Operation of LIFT TOOL by authorized personnel only.
• LIFT TOOL intended for use to assist, lift, install, remove units (load) up into rack elevations. It is

not to be used loaded transporting over major ramps nor as a replacement for such designated

tools like pallet jacks, walkies, fork trucks and such related relocation practices. When this is not

practicable, specially trained persons or services must be used (for instance, riggers or movers).

• Read and completely understand the contents of LIFT TOOL operator's manual before using.

Failure to read, understand, obey safety rules, and follow instructions may result in property

damage and/or personal injury. If there are questions, contact the vendor's service and support.

Local paper manual must remain with machine in provided storage sleeve area. Latest revision

manual available on vendor's web site.

• Test verify stabilizer brake function before each use. Do not over-force moving or rolling the LIFT

TOOL with stabilizer brake engaged.

• Do not raise, lower or slide platform load shelf unless stabilizer (brake pedal jack) is fully

engaged. Keep stabilizer brake engaged when not in use or motion.

• Do not move LIFT TOOL while platform is raised, except for minor positioning.
• Do not exceed rated load capacity. See LOAD CAPACITY CHART regarding maximum loads at

center versus edge of extended platform.

• Only raise load if properly centered on platform. Do not place more than 200 lb (91 kg) on edge

of sliding platform shelf also considering the load's center of mass/gravity (CoG).

• Do not corner load the platforms, tilt riser, angled unit install wedge or other such accessory

options. Secure such platforms -- riser tilt, wedge, etc options to main lift shelf or forks in all four

(4x or all other provisioned mounting) locations with provided hardware only, prior to use. Load

objects are designed to slide on/off smooth platforms without appreciable force, so take care not

Safety notices xi