v
A 2.5 inch drive must be positioned at the rear of the tray. While you hold both the drive and the
tray, turn the tray over. Fasten the drive to the bottom of the tray with four screws, as shown in
Figure 11.
6.
Hold the drive tray by the bottom as you position the drive tray. Slide the drive try all the way into
the system. Push the drive tray in until the drive tray handle (A) starts to close, then push the handle
in until it locks, as shown in Figure 12 on page 14.
Figure 10. Mounting the 3.5 inch drive in the tray
Figure 11. Mounting the 2.5 inch drive in the tray
Installing and configuring the system
13
Summary of Contents for Power Systems S812LC 8348-21C
