4.1 Restoring the Partition
If a system or hard disk problem prevents system setup or diagnostic
programs from being loaded from the protected partition, load and run the
programs from the Reference Diskette. If no errors are found, restore the
programs to the protected partition on the hard disk using the following
procedure.
1. Start the system with the customer's backup copy of the Reference
Diskette installed.
2. Select the Backup/Restore system programs from the Main Menu.
3. Select the Restore the system partition to load the system setup and
utility programs, and the customer and advanced diagnostics programs
onto the system partition of the hard disk.
If this does not correct the problem, use the backup copy of the Reference
Diskette to format the hard disk and then restore the programs to the
protected partition. If the problem remains, return to the I998XXXX,
I9990303 error code (on page 11.4 in the Symptom-to-FRU index).
Note: After the programs have been restored, the Diskette and F1 prompts
appear, unless an operating system is present.
IBM PS/2 Model CL57 SX HMS
Restoring the Partition
¦ Copyright IBM Corp. 1992
4.1 - 1
