Replacing a failed power supply
Before you begin
When you replace a failed power supply, do not unplug the power supply unit that is working. This
action disrupts service to the appliance.
Procedure
1.
Remove the failed power supply from the power supply bay by pinching the side clip and pulling the
failed power supply from the bay, as shown in Figure 2.
Important:
During normal operation, each power supply bay must contain either a power supply or a power
supply blank for proper cooling.
2.
Slide the AC power supply into the bay until the retention latch clicks into place. Make sure that the
power supply connects firmly to the power supply connector.
3.
Connect the power cord for the new AC power supply to the power cord connector on the power
supply. The AC power supply connectors on the back of the appliance are shown in the following
figure:
Figure 2. Removing the power supply from the back of the appliance
Power Supply Replacement Instructions
3
Summary of Contents for QRadar XGS 5200
Page 1: ...IBM Security IBM ...
Page 2: ......
Page 7: ...Power Supply Replacement Instructions 5 ...
Page 8: ...IBM Printed in USA ...