b) Click the rear bracket into place on the rear frame (
6
).
c) Close the rear latch hook (
7
).
8. Using an M5 x 10 mm screw and M5 washer, anchor the front bracket to the front frame (
8
).
9. Using an M5 x 10 mm screw and M5 washer, anchor the rear bracket to the rear frame (
9
).
10. Repeat steps “6” on page 22-“9” on page 23 for the opposite rail.
Installing the SAN Volume Controller 2145-SV1 in a rack
After you install the support rails, you can install the SAN Volume Controller 2145-SV1 node in the rack.
Before you begin
CAUTION: To avoid any hazard from the rack tipping forward when devices are installed, observe
all safety precautions for the rack into which you are installing the device.
CAUTION: The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb). It takes two
persons to safely lift this part or unit. (C009)
Procedure
To install the SAN Volume Controller 2145-SV1 node in the rack, complete the following steps.
1. Fully extend the middle section of the rail from the outer section on both sides and lock it in place.
Figure 25. Insert the chassis into the rack
2. Make sure that the ball bearing retainer is located at the front of the middle section of the rail.
3. With the help of multiple persons, lift the chassis until the inner section of the rail (attached to the
chassis) is aligned with the middle section (
1
).
4. Insert the chassis and inner member into the middle section of the rail until it stops (
2
,
3
).
5. Pull or push the release tab to unlock (
4
), and then retract the chassis into the rack.
6. If you ship the rack with the chassis attached, tighten the shipping screws in the front of the chassis
before you ship the rack (
5
).
Chapter 2. Installing the SAN Volume Controller 2145-SV1 hardware 23
Summary of Contents for SAN Volume Controller 2145-SV1
