5.
Is the default IP address correct?
v
If
yes
, return to the configuration menu, and then go to Step 7.
v
If no, enter the IP address of the SiteProtector SP3001 appliance in the field provided.
Note:
Press
UP
or
DOWN
to select a number, and then use the
LEFT
or
RIGHT
buttons to move to
another digit.
6.
Select
OK
, and then press the
ENTER
button to confirm.
7.
Repeat Steps 4 through 6 to enter the following information:
v
subnet mask
v
default gateway
v
DNS server
v
host name
Note:
Certain characters cannot be used in the host name. See the Microsoft article at
http://support.microsoft.com/kb/909264 for details on naming conventions.
Note:
The SiteProtector SP3001 appliance provides a default subnet mask and gateway address that is
based on the IP address that you enter. You can skip the procedure for entering these addresses if you
verify that the default gateway and subnet addresses are correct. See “SiteProtector SP3001 appliance
configuration checklist” on page 11.
A final confirmation screen appears.
Note:
If you want the SiteProtector SP3001 appliance to ignore the information that you have entered,
select
Cancel
, and then press
ENTER
.
8.
Select
OK
, and then press
ENTER
to confirm. The SiteProtector SP3001 appliance saves the
configuration information you entered.
Note:
The SiteProtector SP3001 appliance restarts automatically if you change the IP address or the
host name of the appliance.
What to do next
You have now connected the SiteProtector SP3001 appliance to the network using the LCD panel, so you
are ready to download the SiteProtector Console and point it to the appliance. From the SiteProtector
Console, you can install licenses. Then you will need to change administrator and database passwords.
Installing and starting the SiteProtector Console
To connect to SiteProtector for the first time, you must download, install, and start the SiteProtector
Console on your computer.
Installing the SiteProtector Console
Procedure
1.
Access the IBM Security Download Center at https://ibmss.flexnetoperations.com.
2.
Login to the IBM Security Download Center and click
Download
from under the My software
heading.
3.
Under My Products, click
IBM Security SiteProtector System
.
4.
Under Product Lines, click
SiteProtector 3.0
.
5.
Click the
Installation Packages
link.
6.
Download the
Console-Setup.exe
package to a known location.
7.
Run
Console-Setup.exe
.
Chapter 3. Connecting and configuring the SiteProtector SP3001 appliance
15
Summary of Contents for SP3001
