DANGER
Main Protective Earth (Ground):
This symbol is marked on the frame of the rack.
The PROTECTIVE EARTHING CONDUCTORS should be terminated at that
point. A recognized or certified closed loop connector (ring terminal) should
be used and secured to the frame with a lock washer using a bolt or stud.
The connector should be properly sized to be suitable for the bold or stud,
the locking washer, the rating for the conducting wire used, and the
considered rating of the breaker. The intent is to ensure the frame is
electrically bonded to the PROTECTIVE EARTHING CONDUCTORS. The
hole that the bolt or stud goes into where the terminal conductor and the lock
washer contact should be free of any non-conductive material to allow for
metal to metal contact. All PROTECTIVE EARTHING CONDUCTORS
should terminate at this main protective earthing terminal or at points
marked with
. (R010)
Special caution and safety notices
This information describes special safety notices that apply to the Storwize V7000.
These notices are in addition to the standard safety notices supplied and address
specific issues relevant to the equipment provided.
General safety
When you service the Storwize V7000, follow general safety guidelines.
Use the following general rules to ensure safety to yourself and others:
v
Observe good housekeeping in the area where the devices are kept during and
after maintenance.
v
Follow the guidelines when lifting any heavy object:
1.
Ensure that you can stand safely without slipping.
2.
Distribute the weight of the object equally between your feet.
3.
Use a slow lifting force. Never move suddenly or twist when you attempt to
lift.
4.
Lift by standing or by pushing up with your leg muscles; this action removes
the strain from the muscles in your back.
Do not attempt to lift any objects that
weigh more than 18 kg (40 lb) or objects that you think are too heavy for you.
v
Do not perform any action that causes a hazard or that makes the equipment
unsafe.
v
Before you start the device, ensure that other personnel are not in a hazardous
position.
v
Place removed covers and other parts in a safe place, away from all personnel,
while you are servicing the unit.
v
Keep your tool case away from walk areas so that other people will not trip over
it.
x
IBM Storwize V7000: Expansion Enclosure Installation Guide
Summary of Contents for Storwize V7000
