8.1
Lift the server to the height of the slides, and position the set of wheels
at the
back of the system between the rail guides.
B
From the back of the rack, fully extend the slide rails
until the rails lock into the
extended position.
A
8
Install the server onto the slide rail
assemblies
Before installing the server onto the slide rail assembly, ensure that the
leveling feet are extended and that the stabilizer bracket is correctly installed
to prevent the rack from falling forward.
Tip:
Read this entire task before completing any individual steps.
CAUTION:
This part or unit is heavy but has a weight smaller than 18 kg (39.7
lb). Use care when lifting, removing, or installing this part or unit. (C008)
8.2
8.3
Push the server into the slide rails until the rear slide release latches
click into
place, locking the server into the slide rails.
C
Important:
The latch strikes on the front of the slide rail and the cable-
management arm brackets must be installed before installing a server onto the
rails. If these parts are not installed, the installation may cause the rails to
compress and the server might fall out of the rack.
A
B
D C