connector on the back panel of the library, if the library is the last or only
device on the SCSI bus. Otherwise, attach one end of a SCSI cable to the
remaining port and the other end to the next device on the SCSI bus. Make
sure that the last device on the SCSI bus is properly terminated.
Note:
Only cables and terminators specified for Ultra160 or Ultra320 use or
labeled as Multi Mode should be used.
Note:
The host bus adapter should be LVD SCSI. A single-ended (SE) SCSI
host bus adapter will work, but will severely degrade performance,
and limit cable length. If there are any SE devices on the same SCSI
bus, the entire SCSI bus will negotiate down to SE speed and severely
degrade performance.
v
For a Fibre Channel library, connect the host interface cable to the host or to
a switch. If an SC-to-LC interposer is required, refer to “Installing a Fibre
Channel Interposer (Feature Code 5096).”
v
For a SAS library, connect the Host Interface Cable to the host HBA, using a
direct SFF-8088 connection, or an interposer as required. Unused SAS
connectors do not need termination.
4.
Plug the network ethernet cable (
2
in Figure 4-17 on page 4-15,
5
in
Figure 4-18 on page 4-15, or
3
in Figure 4-19 on page 4-15) into the ethernet
port on the back panel of the library. If the ethernet connection is directly
attached to a server or laptop, a crossover ethernet cable may be required.
Note:
It is the customer's responsibility to supply the crossover cable if one is
required.
Installing a Fibre Channel Interposer (Feature Code 5096)
For a list of supported adapters and required interposers, go to the Technical
Support section on the web at
http://www.ibm.com/storage/
.
To install the interposer, refer to the procedure below.
1.
Connect the host SC fibre cable to the matching side of the interposer.
2.
Connect the drive LC fibre side of the interposer to the drive/library.
a67m0276
Host
Fibre
Channel
Network
Library
Fibre
Channel
Drive
Connector
11P1373
Figure 4-20. Interposer installation
4-16
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Summary of Contents for System Storage TS3100
