1. Make sure that the levers are in the open position before installing node into
chassis
2. Slide the system-board tray into the chassis until it stops.
3. Close the two release latches inward.
4. Reconnect the cables to the front of the system-board tray.
5. Turn on the system-board tray (see “Turning on the node” on page 10).
6. Make sure that the power-on LED on the system-board tray operator panel is lit
continuously, indicating that the system-board tray is receiving power and is
turned on.
If you are installing a different system-board tray from the one that you removed,
you might have to configure the system-board tray using the Setup utility. See
“Using the Setup utility” on page 345 for more information.
Removing the system-board tray cover
To remove the server cover, complete the following steps:
Release
latch
System-board
tray cover
System-board
tray
1. Read the safety information that begins on page vii and “Installation guidelines”
2. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 279).
3. Carefully set the system-board tray on a flat, static-protective surface, with the
cover side up.
4. Pull up firmly on the blue latch on the top of the system-board tray; then, lift the
cover open.
5. If you are instructed to return the system-board tray cover, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing the system-board tray cover
To install the system-board tray cover, complete the following steps:
Attention:
You cannot insert the system-board tray into a chassis until the cover
is installed and closed. Do not attempt to override this protection.
280
System x iDataPlex dx360 M4 Types 7912 and 7913: Problem Determination and Service Guide
Summary of Contents for System x iDataPlex dx360 M4 7912
